Rename .test/test{} to .testscript/testscript{}

1 files changed, 0 insertions, 61 deletions

diff --git a/tests/common.test b/tests/common.test
deleted file mode 100644
index 46c4de9..0000000
--- a/tests/common.test
+++ /dev/null
@@ -1,61 +0,0 @@
-# file      : tests/common.test
-# copyright : Copyright (c) 2014-2018 Code Synthesis Ltd
-# license   : MIT; see accompanying LICENSE file
-
-# Commonly-used variables setup and driver command line.
-#
-
-# Use the same build system driver as the one running the tests (as opposed
-# to one that may or may not be found via PATH). Note that this implies that
-# we don't support cross-testing.
-#
-# A common approach will be to run build2 as a sanity check in a directory
-# produced or updated by a command being tested.
-#
-build = $recall($build.path)
-test.options += --build $build
-
-# Check that git version is the minimum supported one or above. The lowest
-# common denominator for bdep commands is 2.1.0.
-#
-+git --version | set git_version_out
-
-+echo "$git_version_out" | sed -n -e 's/git version (\d+\.\d+\.\d+).*/\1/p' | \
- set git_version
-
-+if ("$git_version" == "")
-  exit "unable to obtain git version from '$git_version_out'"
-end
-
-+echo "$git_version" | sed -e 's/(\d+).*/\1/'      | set git_version_major
-+echo "$git_version" | sed -e 's/\d+\.(\d+).*/\1/' | set git_version_minor
-
-+if! ($git_version_major >  2 || \
-      $git_version_major == 2 && $git_version_minor >= 1)
-  exit "minimum supported git version is 2.1.0"
-end
-
-# Helper commands that can be used by tests to prepare the testing environment
-# or validate an outcome of the command being tested. They are likely to get
-# additional options and redirects appended prior to use. A common approach
-# will be to redirect output to the null device for commands that are used for
-# test setup, and to match it for commands being tested or performing teardown
-# (for example, to make sure that configuration post-test state is valid and is
-# as expected).
-#
-clean   = $* clean
-deinit  = $* deinit
-init    = $* init
-fetch   = $* fetch
-new     = $* new --no-checks
-status  = $* status
-sync    = $* sync
-update  = $* update
-config  = $* config
-publish = $* publish
-
-# All testscripts are named after bdep commands, for example sync.test. So the
-# testscript scope id is a name of the command being tested.
-#
-cmd = [string] $@
-test.arguments = $cmd